Instrument Cluster Scan Tool Information
|
Instrument Cluster Scan Tool Information
|
Instrument Cluster Scan Tool Data Parameters
Parameter
|
Expected Value
|
Description
|
Operating Conditions:
Ignition ON
|
Ambient Air Temperature
|
15 °C
|
The scan tool displays outside temperature in °C.
|
Battery Voltage
|
12-14 V
|
The scan tool displays volts. This is the current battery voltage signal.
|
Coolant Level Switch
|
Open
|
The scan tool displays either Open, Closed, or Not Available.
|
Driver Information Center Reset Switch
|
Active/Inactive
|
The scan tool displays Active or Inactive. This is the state of the driver information center reset switch.
|
Driver Information Center Switch
|
Varies
|
The scan tool displays volts. This is the current driver information center switch input voltage.
|
Driver Information Center Switch
|
Inactive
|
The scan tool displays either Inactive, Up, Down, or Menu. This is the state of the driver information center switch.
|
Key in Ignition Status
|
Active/Inactive
|
The scan tool displays Active or Inactive. This is the state of the key in ignition switch.
|
Reset Switch
|
Active/Inactive
|
The scan tool displays Active or Inactive. This is the state of the reset switch.
|
Washer Fluid Heater
|
Off
|
The scan tool displays either Off, On, or Not Available.
|
Washer Fluid Level Switch
|
Open
|
The scan tool displays either Open, Closed, or Not Available.
|
Instrument Cluster Scan Tool Output Controls
Output Control
|
Description
|
All Indicators
|
This function is used to command all the indicators ON or OFF.
|
CAN Bus Configuration Learn
|
This function is used to Reset the source ID for low speed CAN Bus communications.
|
Driver Information Center Dimming
|
This function is used to command the dimming of the driver information display to Increase or Decrease by 10%.
|
Driver Information Center Options
|
This function is used to command the driver information center buttons using the scan tool.
|
Driver Information Center Segments
|
This function is used to command the driver information center segments ON and OFF.
|
Instrument Cluster Gauge Sweep
|
This function is used to command the gauges to sweep from minimum to maximum.
|
Instrument Panel Cluster Dimming
|
This function is used to command the dimming of the instrument cluster to Increase or Decrease by 10%.
|
Odometer Programming
|
This function is used to command the odometer to reset.
|