Bosch Connectors (BSK)
| Bosch Connectors (BSK) |
Special Tools
For equivalent regional tools, refer to Special Tools .| Terminal Removal Procedure |
| 1. |
Disconnect the connector from the component.
|
|
| 2. |
Remove the wire dress cover, if necessary.
|
|
| 3. |
Push the wire side of the terminal that is being removed toward the connector and hold it in position.
|
|
| 4. |
Insert the EL-38125-561 tool into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage the terminal retainers.
|
|
| 5. |
Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.
|
|
| Terminated Lead Repair |
| 1. |
Remove the terminal.
|
|
| 2. |
Find the appropriate terminated lead.
|
|
| 3. |
Use the appropriate splice sleeves depending on the gauge size.
|
|
| 4. |
Refer to
Splicing Copper Wire Using Splice Sleeves
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
