Measuring Voltage
Measuring Voltage |
Special Tools
EL 39200 Digital Multimeter (DMM)For equivalent regional tools, refer to Special Tools .
Refer to Test Probe Caution .
The following procedure measures the voltage at a selected point in a circuit.
1. |
Disconnect the electrical harness connector for the circuit being tested, if necessary.
|
2. |
Enable the circuit and/or system being tested. Use the following methods:
|
• |
Turn ON the ignition, with the engine OFF.
|
• |
Start the engine.
|
• |
Turn ON the circuit and/or system with a scan tool in Output Controls.
|
• |
Turn ON the switch for the circuit and/or system being tested.
|
3. |
Select the V (AC) or V (DC) position on the Digital Multimeter (DMM).
|
4. |
Connect the positive lead of the DMM to the point of the circuit to be tested.
|
5. |
Connect the negative lead of the DMM to a good ground.
|
6. |
The DMM displays the voltage measured at that point.
|