Differential Carrier Bushing Replacement - Front
|
|
Differential Carrier Bushing Replacement - Front
|
|
Callout
|
Component Name
|
Preliminary Procedure
Remove the propeller shaft. Refer to
Propeller Shaft Replacement
.
|
1
|
Differential Splash Shield
Procedures
|
1.
|
Unhook the hooks from the control module and remove the protective cover from the hydraulic pump.
|
|
2.
|
Unclip the harness and remove the electrical connector.
|
|
2
|
Differential Bushing Fasteners
Procedures
|
1.
|
Use a column jack as support for the differential clutch and limited slip differential, secure with strap.
|
|
2.
|
Remove the bolts for the differential clutch and limited slip differential.
|
|
3.
|
Lower the differential clutch and limited slip differential as far as the rubber bushings can be removed, take care that the drive shaft universal joints are not damaged.
|
Tighten
108 Nm (80 lb ft)
|
3
|
Differential Carrier Bushing
Procedures
|
1.
|
Fit the tool DT-49126-1 press tool together with the hydraulic press tool.
|
|
2.
|
Press out the rubber bushing.
|
|
3.
|
For installation fit the rubber bushing in the housing with the bevels and press the bushing into the housing with tool DT-49126-2 press tool and the hydraulic tool.
|
Special Tools
For equivalent regional tools, refer to
Special Tools
.
|
