Rear Brake Caliper Replacement (J61, J62)
|
Rear Brake Caliper Replacement (J61, J62)
|
Callout
|
Component Name
|
Refer to
Brake Fluid Irritant Warning
.
Refer to
Brake Dust Warning
.
Preliminary Procedure
3.
|
Release the tension from the park brake cables.
|
4.
|
Disconnect the park brake cable from the actuator lever on the brake caliper.
|
|
1
|
Brake Hose Fitting Bolt
Refer to
Fastener Caution
.
Note
|
If installing a new brake caliper, hand install the brake hose fitting bolt, the new gaskets and the hose to the new caliper with the caliper inverted to prevent brake fluid loss.
|
Tighten
40 Nm (30 lb ft)
|
2
|
Brake Hose Fitting Gasket (Qty: 2)
Procedures
Install NEW gaskets. Do not re-use the brake hose coupling gaskets.
|
3
|
Brake Hose
Note
|
•
|
Plug the brake caliper inlet port to prevent brake fluid loss and contamination.
|
•
|
Plug the brake hose fitting to prevent brake fluid loss and contamination.
|
|
4
|
Brake Caliper Guide Pin (Qty: 2)
Tighten
27 Nm (20 lb ft)
|
5
|
Rear Brake Caliper
Procedures
1.
|
Use needle nose pliars to turn back the piston.
|
3.
|
With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
|
4.
|
Slowly release the brake pedal.
|
5.
|
Wait 15 seconds, then repeat steps 3-4 until a firm brake pedal is obtained. This will properly seat the brake caliper piston and brake pads.
|
6.
|
Fill the master cylinder reservoir.
|
7.
|
Connect the park brake cable to the actuator lever on the caliper.
|
Note
|
New brake calipers come prepared filled with brake fluid. Do NOT drain brake fluid from a new caliper before installing. Draining the brake fluid from the new brake caliper will prevent the brake caliper from bleeding properly.
|
|