SAAB WIS ONLINE

Rear Axle Lower Control Arm Replacement (GNE)

Rear Axle Lower Control Arm Replacement (GNE)



Callout Component Name

Preliminary Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

3. Remove the rear spring. Refer to Rear Spring Replacement (GNC) Rear Spring Replacement (GNE) .

4. AWD: Remove the wheel drive shaft retaining nut and disengage the wheel drive shaft spindle from the wheel hub assembly. Refer to Rear Wheel Drive Shaft Replacement .

5. Remove the shock absorber lower fastener. Refer to Shock Absorber Replacement (GNC) Shock Absorber Replacement (GNE) .


1

Rear Suspension Link Fastener

Refer to Fastener Caution .


Procedures

1. Install a NEW bolt.

2. Torque on nut.


Tighten

150 Nm (111 lb ft) + 60 degrees + 15 degrees

2

Rear Suspension Lower Control Arm Fastener (Qty: 2)


Procedures

1. Install a NEW bolt.

2. Torque on nut.


Tighten

115 Nm (85 lb ft) + 90 degrees + 15 degrees

3

Rear Axle Lower Control Arm

Procedures

Use a proper jack stand to load the control arm when tightening the fasteners.