Engine Coolant Heater Control Module Replacement

/ 9-5 (9650) / 2010 / 8. Body / Climate system / Adjustment/replacement / Engine Coolant Heater Control Module Replacement

Removal Procedure

1.	Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

2.	Remove instrument panel compartment. Refer to Instrument Panel Compartment Replacement .

3.	Remove the both engine coolant heater control module fasteners (1).

4.	Disconnect the electrical connector (1) from the engine coolant control module (2).

5.	Remove the engine coolant control module.

Installation Procedure

1.	Install the engine coolant control module to the instrument panel tie bar anchor plate.

2.	Connect the electrical connector (1) to the engine coolant control module (2).

3.	Install the instrument panel compartment. Refer to Instrument Panel Compartment Replacement .

4.	Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.