Rear Compartment Lid Emblem/Nameplate Replacement
|
Rear Compartment Lid Emblem/Nameplate Replacement
|
Callout
|
Component Name
|
1
|
Rear Compartment Lid Emblem/Nameplate
Refer to
Exterior Trim Emblem Removal Caution
.
Procedures
1.
|
The part and surface should be
21°C (70°F)
prior to installation. The vehicle should remain
21°C (70°F)
for one hour after assembly to allow adhesive to develop sufficient bond strength.
|
2.
|
Use a heat gun 260-400°C (500-750°F), or equivalent, to remove the old nameplate. Clean all adhesive from the rear compartment panel and wipe the surface dry with a clean lint-free towel prior to installing the new name plate.
|
3.
|
When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
|
4.
|
Close the rear compartment lid prior to adhesion.
|
5.
|
Using the palm of the hand, wet out the name plate to the rear compartment lid to ensure full adhesion of the name plate is made.
|
|