SAAB WIS ONLINE

Front Seat Belt Retractor Replacement

Front Seat Belt Retractor Replacement



Callout Component Name
Refer to SIR Warning .

Warning

In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflator module as normal shop waste. Undeployed inflator modules contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed inflator module. Failure to observe the following disposal methods may be a violation of federal, state, or local laws.



Preliminary Procedure

1. Disable the SIR. Refer to SIR Disabling and Enabling .

2. Remove the front and rear side door sill trim plate. Refer to Front and Rear Side Door Sill Trim Plate Replacement .

3. Remove the center pillar lower trim panel. Refer to Center Pillar Lower Trim Panel Replacement .

4. Remove the center pillar upper trim panel. Refer to Center Pillar Upper Garnish Molding Replacement .


1

Front Seat Belt Retractor Guide Fastener

Refer to Fastener Caution .

Tighten

45 Nm (33 lb ft)

2

Front Seat Belt Retractor Guide Retainer

3

Front Seat Belt Retractor Fastener

Procedures

Disconnect the electrical connector.

Tighten

45 Nm (33 lb ft)

4

Front Seat Belt Tensioner Cover Bolt Cover

5

Front Seat Belt Tensioner Cover Bolt

Tighten

5 Nm (44 lb in)

6

Front Seat Belt Tensioner Cover

7

Front Seat Belt Retractor