Seat Belt Latch Stop Installation
|
Seat Belt Latch Stop Installation
|
Callout
|
Component Name
|
Preliminary Procedure
1.
|
Locate the hole in the seat belt webbing where the original seat belt stop button was located.
|
2.
|
If the original hole in the seat belt webbing is not visible, perform the following:
|
|
•
|
If either the right or left stop button is missing use the opposing seat belt as a reference.
|
|
•
|
With the opposing seat belt fully stowed, measure the distance between the seat belt lower anchor and the stop button.
|
|
•
|
Using the measurement obtained above, measure and mark the location of the missing stop button on the center of the seat belt webbing.
|
3.
|
Ensure the seat belt latch plate is located above the mark or original hole.
|
|
1
|
Seat Belt Latch Stop
Procedures
1.
|
Work the male half of the stop button through the hole in the webbing or at the marked location.
|
2.
|
Align the female half of the stop button with the male half of the stop button.
|
3.
|
Snap the two halves together.
|
4.
|
Trim off any access of the male half of the stop button flush with the female half of the stop button.
|
Note
|
Ensure the male half of the stop button is facing forward in the vehicle in order to ensure the stop button will not snag customers clothing.
|
|