Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor)
|
Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor)
|
Perform the Initialization/Teach Process any time a new sunroof motor actuator is installed in the vehicle.
"Manual" indicates the first switch detent
"Express" indicates the second switch detent
1.
|
Ensure that the electrical harness on the headliner is connected to the sunroof motor.
|
2.
|
Put the ignition in the RUN position. (CAL file will be automatically downloaded by Body Control housing, BCM).
"Manual close" is allowed and limited "manual open" is allowed
|
3.
|
Re-initialization (Normalization) - Press "manual close switch" until glass/roller blind finds hard stop. After initialization "express open" is allowed but not "express close"
|
|
4.1.
|
Open the sunroof window/sunshade with the express or manual open the switch to the full open position the release the switch.
|
|
4.2.
|
Press "manual open switch" for more than 10 seconds or until the sunroof window starts AND reaches the closed position.
|
5.
|
Verify the operation of the sunroof.
|
Note
|
The Initialization/Teach Process is not complete if any of the following actions take place before the initialization cycle is done:
|
•
|
The sunroof switch is not held in the close position.
|
•
|
The ignition and/or battery power has been removed.
|
•
|
The glass panel has not reached the closed position.
|
The Initialization/Teach Process must be restarted if the procedure is not carried out completely.
|