SAAB WIS ONLINE

Sunroof Sunshade Replacement

Sunroof Sunshade Replacement

Removal Procedure


1. Open the sunshade.


2. Lower the molded headlining. Refer to Headlining Trim Panel Replacement (With Sunroof) Headlining Trim Panel Replacement (Without Sunroof) .

3.
Important

The sunshade is blocked and cannot roll open.


Lock the sunshade.

3.1. Manually roll the sunshade until the notch (1) is almost vertical to the sunshade.

3.2. Place a bolt pin (2) approximately 1 mm (0.04 in) thick on the left side in the notch in order to prevent the rolling open of the sunshade spring.

4. Remove the rear crossmember.

Remove the 4 bolts (1) and remove the rear crossmember.


5. Remove the sunshade at the rails.

Remove the 2 bolts (1).


6. Remove sunshade.

Disconnect the sunshade (90 degree rotation) and remove.


Installation Procedure


1.
Important

Ensure that the sunshade cover is correctly placed into the guide (1)


Insert the sunshade.


1.1. Insert the sunshade into the guide and lock into position.

1.2. Insert the sunshade in the guide rails until the stop (2).

2. Install the sunshade at the rails.

Tighten

Tighten the 2 bolts to 2.5 Nm (22 lb in).

3. Install the rear crossmember.

4. Disconnect the sunshade.

Remove the pin.

Tighten

Tighten the sunshade.

5. Close the sunshade

6. Install the headlining. Refer to Headlining Trim Panel Replacement (With Sunroof) Headlining Trim Panel Replacement (Without Sunroof) .