SAAB WIS ONLINE

Crankshaft and Bearing Installation

Crankshaft and Bearing Installation


Special Tools

EN-45059 Torque Angle Sensor Kit



1.
Note

Inspect installation position.


Install the crankshaft bearing clips, oil bearing clips.


2. Install the crankshaft.

3.
Note

Inspect installation position.


Install the crankshaft bearing caps 1-4.

Oil bearing clips.

Install the 8 bolts.

4.
Note

Inspect installation position.


Install the crankshaft bearing cap.

4.1. Apply black adhesive sealing compound to the grooves of the rear crankshaft bearing cap.

4.2. Install the 2 bolts.

5. Refer to Fastener Caution .

Tighten the crankshaft bearing cap (1).


6. Install 10 NEW bolts and tighten in 3 passes using the EN-45059 sensor kit:

First pass in sequence to 50 Nm(37 lb ft) .

Second pass to 45 degrees .

Third pass to 15 degrees .

7.
Note

Inspect installation position.


Install the connecting rod bearing caps 2 and 3 (1) and oil the bearing clips.


8. Tighten the 4 connecting rod bearing cap bolts in 3 passes using the EN-45059 sensor kit:

First pass in sequence to 35 Nm (26 lb ft)

Second pass to 45 degrees

Third pass to 15 degrees

9. Turn the crankshaft through 180 degrees.


10.
Note

Inspect installation position.


Install the connecting rod bearing caps 1 and 4 (1) and oil the bearing clips.

11. Tighten the 4 connecting rod bearing cap bolts in 3 passes using the EN-45059 sensor kit:

First pass in sequence to 35 Nm (26 lb ft)

Second pass to 45 degrees

Third pass to 15 degrees