Cylinder Sleeve Removal
Cylinder Sleeve Removal |
Special Tools
EN-45680-850 Cylinder Sleeve Removal and Installation KitFor equivalent regional tools, refer to Special Tools (LDK, LHU) .
2. |
Install
EN-45680-852
cylinder bore sleeve puller (1) through the cylinder bore.
|
3. |
Align the shoe (1) of EN-45680-852 cylinder bore sleeve puller to the bottom of the cylinder bore sleeve (117). |
4. |
Hold the threaded shaft of
EN-45680-852
cylinder bore sleeve puller upward in order to retain the shoe alignment to the bottom of the cylinder bore sleeve.
|
5. |
Install
EN-456850-851
fixture (4) onto the threaded shaft of
EN-456850-852
cylinder bore sleeve puller and the engine block.
|
6. |
Install the bearing (3) and the nut (1).
|
7. |
Tighten the nut (1) to the bearing (3).
|
8. |
Refer to
Fastener Caution
.
Install the 4 bolts (2) into the cylinder head bolt holes in the block and tighten to 15 Nm (11 lb ft) . |
9. |
Rotate the nut clockwise in order to remove the cylinder bore sleeve (1).
|
10. |
Remove EN-45680-851 fixture , EN-45680-852 cylinder bore sleeve puller and the cylinder bore sleeve (117) from the engine block. |
11. |
Loosen the nut (1) in order to remove the cylinder bore sleeve (117).
|
12. |
Inspect the cylinder bore in the cylinder block for cracks or damage. If cracked or damaged, replace the cylinder block.
|
13. |
Inspect the piston, piston rings, and connecting rod for damage. Refer to
Piston, Connecting Rod, and Bearing Cleaning and Inspection (LDK, LHU)
.
|