SAAB WIS ONLINE

Fuel Rail and Injectors Installation (LDK, LHU)

Fuel Rail and Injectors Installation (LDK, LHU)



Special Tools

• EN-47909 Injector Bore and Sleeve Cleaning Kit

• EN 48896 HP Fuel Pump Installation Alignment Gauge


For equivalent regional tools, refer to Special Tools (LDK, LHU) .


1. Clean the injector bore in the cylinder head using the EN-47909 cleaning kit.


2. Install the fuel rail with the fuel injectors into the cylinder head evenly.

3. Hand tighten the 2 outer fuel rail bolts to seat the injector into the injector bores.

4. Refer to Fastener Caution .

Start and hand tighten the remaining fuel rail bolts.

4.1. Tighten the fuel rail bolts in sequence to 22 Nm (16 lb ft) .

4.2. Tighten the fuel rail bolts in sequence a second time to 22 Nm (16 lb ft) .

5. Install the fuel injector noise insulator (1).


6. Connect the electrical harness to the fuel rail harness connection.

7.
Note

The camshaft must be in the base circle position before the high pressure fuel pump is installed.


Use the EN-48896 alignment gauge (2) to ensure that the camshaft lobe is in the base circle position. At base circle position, the tool will be flush with the head (1).


8. Lubricate the high pressure fuel pump cylinder head bore with 5W30 engine oil.


9.
Note

Ensure that the high pressure fuel pump roller lifter is oriented properly, the camshaft is at base circle, and the number 1 piston is at top dead center (TDC) on the exhaust stroke. The distance from the mounting flange surface to the camshaft at base circle should be 52 mm (2.05 in).


Lubricate the high pressure fuel pump roller lifter (1) with 5W30 engine oil and install into the cylinder head bore.

10. Install a NEW high pressure fuel pump gasket (1).


11. Install a NEW high pressure fuel pump O-ring (2).

12.
Note

Ensure the plastic bolt retainers are installed in the high pressure fuel pump mounting holes before installing.


Install the high pressure fuel pump (3).

13. Start and hand-tighten the high pressure fuel pump bolts evenly.

14. Tighten the high pressure fuel pump bolts evenly to 15 Nm (11 lb ft) .

15. Install and hand-tighten both ends of the NEW high pressure fuel line (1).


16. Tighten the high pressure fuel line fitting nuts to 30 Nm (22 lb ft) .