Camshaft Installation - Right Side
|
|
Camshaft Installation - Right Side
|
|
1.
|
Ensure that the camshaft sealing rings (1) are in place in the camshaft grooves. Camshaft sealing rings must be in place below the surface of the camshaft journal in order to avoid being pinched between the cylinder head and the camshaft caps.
|
|
3.
|
Place the right intake and right exhaust camshafts in position in the right cylinder head.
|
|
4.
|
Position the camshaft lobes in a neutral position with the flats on the back of the camshafts up and parallel (1) with the right cylinder head camshaft cover rail.
|
|
5.
|
Observe the markings on the right cylinder head camshaft bearing caps. Each bearing cap is marked in order to identify its location. The markings have the following meanings:
|
|
|
•
|
The raised feature must always be oriented toward the center of the cylinder head.
|
|
|
•
|
The I indicates the intake camshaft.
|
|
|
•
|
The E indicates the exhaust camshaft.
|
|
|
•
|
The number 1, 3, 5 indicates the cylinder position from the front of the engine.
|
|
7.
|
There are first design (1) and second design (2) camshaft front bearing caps.
|
|
8.
|
For applications that have a second design camshaft bearing cap (2), apply a liberal amount of lubricant to the camshaft bearing cap and camshaft thrust surface. Refer to
Adhesives, Fluids, Lubricants, and Sealers
for the recommended lubricant.
|
|
9.
|
|
Note
|
|
There are first design (1) and second design (2) camshaft intermediate bearing caps.
|
Install the camshaft bearing thrust caps in the first journal of the right cylinder head.
|
|
10.
|
Install the remaining bearing caps with their orientation mark toward the center of the cylinder head.
|
|
11.
|
Hand start all the camshaft bearing cap bolts.
|
|
12.
|
Refer to
Fastener Caution
.
Tighten the camshaft bearing cap bolts in sequence as shown to
10 Nm (89 lb in)
.
|
|
13.
|
Loosen the center intake camshaft bearing cap bolts (1, 2) and the center exhaust camshaft bearing cap bolts (3, 4).
|
|
14.
|
Retighten the center camshaft bearing cap bolts (1, 2, 3, 4) and retighten the camshaft bearing cap bolts to
10 Nm (89 lb in)
.
|
