Symptoms - Engine Cooling
|
Symptoms - Engine Cooling
|
Important Preliminary Inspections Before Starting
|
Before using the Symptom diagnosis, perform the following:
|
-
|
Ensure that the engine control module (ECM) and indicator lamp are operating correctly.
|
|
-
|
Ensure that there are no diagnostic trouble codes (DTCs) that are stored.
|
•
|
Verify the customer concern.
|
•
|
Perform the Visual/Physical Inspection in this section. The visual/physical inspection is extremely important, and can lead to correcting a condition without additional testing. It may also help reveal the cause of an intermittent condition.
|
•
|
Locate the correct symptom. Perform the tests and inspections associated with the symptom.
|
Review the system operation in order to familiarize yourself with the system functions. Refer to
Cooling Fan Description and Operation (LHU/A20NFT, LAU/A28NER)
.
Visual/Physical Inspection
|
Several of the symptom procedures call for a careful visual and physical inspection. This can lead to correcting a condition without further tests and can save time. This inspection should include the following areas:
•
|
Ensure that the control module grounds are clean, tight, and correctly located.
|
•
|
Inspect cooling system hoses and pipes for splits, kinks, and proper connections. Inspect thoroughly for any type of a leak or a restriction.
|
•
|
Inspect for a dirty or restricted radiator and HVAC condenser.
|
•
|
Inspect for aftermarket devices which could affect the operation of the Cooling System.
|
•
|
Inspect the easily accessible or visible system components for obvious damage or conditions which could cause the symptom.
|
•
|
Inspect the surge tank reservoir for the proper coolant level.
|
Identifying Intermittent Conditions
|
Many intermittent conditions occur with harness or connector movement due to engine torque, rough pavement, vibration or physical movement of a component. Refer to the following for a list to help determine an intermittent condition:
•
|
Moisture and water intrusion in connectors, terminals, and components
|
•
|
High resistance in circuits or components. High resistance can be a resistance, irrespective of size, that disrupts the function of components.
|
•
|
Harness that is located too tight, or chaffed circuits
|
•
|
High or low ambient temperature
|
•
|
High or low engine coolant temperatures
|
•
|
High underhood temperatures
|
•
|
Heat build up in component or circuit due to circuit resistance, poor terminal contact, or high electrical load
|
•
|
High or low system voltage
|
•
|
High vehicle load conditions
|
•
|
Electro-magnetic interference (EMI)/circuit interference from relays, solenoids or other electrical surge
|
•
|
Incorrect installation of non-factory, aftermarket, and after factory add on accessories
|
If an intermittent is determined, refer to
Testing for Intermittent Conditions and Poor Connections
for specific strategies in diagnosing intermittent conditions.
Refer to a symptom diagnostic procedure from the following list in order to diagnose the symptom: