Turbocharger Wastegate Actuator Adjustment
|
Turbocharger Wastegate Actuator Adjustment
|
2.
|
Allow the engine to cool.
|
3.
|
Loosen the lock nut (2).
|
4.
|
Hand tighten the lock nut (1) until it is seated on the wastegate arm and slight spring tension is observed.
|
5.
|
Note
|
•
|
Ensure the wastegate actuator rod does not rotate during the tightening procedure. If the rod does rotate, it will be necessary to start the procedure again.
|
•
|
After the lock nut (1) has been tightened three complete turns, it should not move for the remainder of the procedure.
|
Mark the lock nut (1) with a paint pen to mark a starting position and tighten three complete turns.
|
6.
|
Refer to
Fastener Caution
.
While holding the wastegate rod tighten the nut (2) hand tight.
|
7.
|
Tighten the nut (2) while holding nut (1) in place to
10 Nm (89 lb in)
. Apply threadlock (P/N 12345493) to the wastegate actuator rod threads on both sides.
|