SAAB WIS ONLINE

DTC P0700

DTC P0700

Diagnostic Instructions


• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptor

DTC P0700

Transmission Control Module (TCM) Requested MIL Illumination

Circuit/System Description

The diagnostic trouble code (DTC) indicates that an emission related transmission DTC set in the transmission control module (TCM). The engine control module (ECM) receives the TCM information over the serial data circuit. The ECM turns ON the malfunction indicator lamp (MIL) when the TCM sends a message over the serial data circuit requesting MIL illumination. The DTC information for the ECM will only display DTC P0700, but the Freeze Frame/Failure Records data will display the transmission DTC that set.

Conditions for Running the DTC


• The ignition is ON or engine is running.

• DTC P0700 runs continuously.


Conditions for Setting the DTC

The ECM receives a serial data message from the TCM requesting the ECM to turn ON the MIL lamp.

Action Taken When the DTC Sets

DTC P0700 is a Type A DTC.

Conditions for Clearing the MIL/DTC

DTC P0700 is a Type A DTC.

Diagnostic Aids

Communication codes, U-codes, as well as powertrain codes, P-codes, set in the TCM can cause the TCM to request DTC P0700 to be set in the ECM.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References

Circuit/System Verification


1.
Note

Correct any engine controls and communication DTCs before diagnosing TCM DTCs.


DTC P0700 is an informational diagnostic trouble code. If there are no engine controls or communication DTCs, refer to Diagnostic Trouble Code (DTC) List - Vehicle for diagnosis of TCM DTCs.

2. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.