Fuel Feed Pipe Replacement
Fuel Feed Pipe Replacement |
Removal Procedure |
1. |
Remove the charge air cooler outlet air tube. Refer to
Charge Air Cooler Outlet Air Tube Replacement
.
|
2. |
Relieve the fuel system pressure. Refer to
Fuel Pressure Relief
.
|
3. |
Disconnect the fuel feed pipe quick connect fitting (1) from the fuel feed pipe (2). Refer to
Plastic Collar Quick Connect Fitting Service
.
|
4. |
Loosen the fuel feed pipe from all retainer.
|
5. |
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
|
6. |
Remove the drivetrain and front suspension frame support right side. Refer to Drivetrain and Front Suspension Frame Front Crossmember Replacement (GNA) Drivetrain and Front Suspension Frame Front Crossmember Replacement (GNB) . |
7. |
Remove both AC evaporator thermal expansion valve heat and brake pipe shield fasteners (1). |
8. |
Remove the fuel tank protector. Refer to
Fuel Tank Protector Replacement
.
|
9. |
Remove the fuel pressure sensor. Refer to
Fuel Pressure Sensor Replacement
.
|
10. |
Disconnect the fuel feed pipe quick connect fitting (1) from the fuel feed pipe rear (2). Refer to
Plastic Collar Quick Connect Fitting Service
.
|
11. |
Plug the fuel pipe and cap the fuel feed pipe to prevent fuel loss or contamination.
|
12. |
Remove the fuel feed pipe from the 5 fuel feed pipe retainer.
|
13. |
With the aid of an assistant, remove the fuel feed pipe from the vehicle.
|
Installation Procedure |
1. |
Refer to
Fastener Caution
.
Ensure that the fuel feed pipe and fittings are clean and dry prior to assembly. |
2. |
With the aid of an assistant, install the fuel feed pipe to the vehicle.
|
3. |
Install the fuel feed pipe to the 5 fuel feed pipe retainer.
|
4. |
Connect the fuel feed pipe quick connect fitting (1) to the fuel feed pipe rear (2). Refer to
Plastic Collar Quick Connect Fitting Service
.
|
5. |
Install the fuel pressure sensor. Refer to
Fuel Pressure Sensor Replacement
.
|
6. |
Install the fuel tank protector. Refer to
Fuel Tank Protector Replacement
.
|
7. |
Install both AC evaporator thermal expansion valve heat and brake pipe shield fasteners (1).
|
8. |
Install the drivetrain and front suspension frame support right side. Refer to
Drivetrain and Front Suspension Frame Front Crossmember Replacement (GNA)
Drivetrain and Front Suspension Frame Front Crossmember Replacement (GNB)
.
|
9. |
Lower the vehicle.
|
10. |
Install the fuel feed pipe to all retainer.
|
11. |
Connect the fuel feed pipe quick connect fitting (1) to the fuel feed pipe (2). Refer to
Plastic Collar Quick Connect Fitting Service
.
|
12. |
Inspect for leaks using the following procedure:
|
12.1. |
Turn the ignition ON, with the engine OFF for 2 seconds.
|
12.2. |
Turn OFF the ignition, for 10 seconds.
|
12.3. |
Turn ON the ignition, with the engine OFF.
|
12.4. |
Inspect for fuel leaks.
|
13. |
Install the charge air cooler outlet air tube. Refer to
Charge Air Cooler Outlet Air Tube Replacement
.
|