DTC P2534 (Fuel Pump Control Module)
|
DTC P2534 (Fuel Pump Control Module)
|
DTC P2534
Ignition 1 Switch Circuit Low Voltage
Diagnostic Fault Information
|
Circuit
|
Short to Ground
|
Open or High Resistance
|
Short to Voltage
|
Signal Performance
|
IGN Voltage
|
P2534
|
P2534
|
-
|
-
|
Circuit/System Description
|
The fuel pump control module monitors the ignition voltage circuit in order to determine if the voltage is within the normal operating range.
Conditions for Running the DTC
|
The engine is running.
Conditions for Setting the DTC
|
The fuel pump control module detects that the IGN voltage is less than 6.0 V.
Action Taken When the DTC Sets
|
DTC P2534 is a Type A DTC.
Conditions for Clearing the DTC
|
DTC P2534 is a Type A DTC.
Schematic Reference
Engine Controls Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Fuel System Description
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References
for scan tool information
1.
|
Verify that DTC P0562 is not set.
|
3.
|
Ignition OFF, disconnect the harness connector at the K27 fuel pump control module.
|
4.
|
Ignition ON, test for greater than 11 V between the IGN voltage circuit terminal 15 and ground.
|
5.
|
If less than the specified voltage, test the IGN voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal and the TRANS/IGN/FSCM fuse is open, test the voltage circuit for a short to ground. If the circuit tests normal, test or replace the Run/Crank relay.
|
6.
|
If all circuits test normal, replace the K27 fuel pump control module.
|
Perform the
Diagnostic Repair Verification
after completing the diagnostic procedure.