Inspection/Maintenance (I/M) Test DTC Table

/ 9-5 (9650) / 2011 / 2. Engine / Engine management and fuel system, V6 / Fault diagnosis, fault symptoms / Inspection/Maintenance (I/M) Test DTC Table

System	DTCs Required to Set System Status to YES
If an I/M System Status indicator did NOT update to YES during the Inspection/Maintenance Complete System Set Procedure , review each indicator and reference this table to determine each DTC associated with the I/M System Status Indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included within the conditions are additional DTCs, which if set, may inhibit the DTCs listed below from running. Reviewing and operating the vehicle within the Conditions for Running for each DTC listed below will allow the I/M System Status Indicators to transition to YES.
Catalyst	DTC P0420
EVAP	• DTC P0442 • DTC P0446 • DTC P0450 or P0451 (LAU or LBW) • DTC P0455 or P0497 (LAU or LBW) • DTC P0496
Oxygen Sensor	• DTC P0130 (Without LF1) • DTC P0131, P0132, or P0134 (Without LF1) • DTC P0133, P013A, or P013E (Without LF1) • DTC P0137, P0138, or P0140 (Without LF1) • DTC P2270 (Without LF1) • DTC P2271 (Without LF1)
Oxygen Sensor Heater	• DTC P0030, P0031, P0032, P0036, P0037, or P0038 (Without LF1) • DTC P0135 or P0141 (Without LF1)
Camshaft System	DTC P000A-P000D, P0011, P0014, P0021, or P0024
AIR	• DTC P2431-P2433 • DTC P0418, P2257, or P2258 • DTC P0411

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.