SAAB WIS ONLINE

No Global Positioning System (GPS) Reception

No Global Positioning System (GPS) Reception

Diagnostic Instructions


Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

Review Strategy Based Diagnosis for an overview of the diagnostic approach.

Diagnostic Procedure Instructions provides an overview of each diagnostic category.


Circuit/System Description

The global positioning system antenna is connected to the navigation radio by a coaxial cable. The antenna cable also provides a path for DC current for powering the antenna.

Reference Information

Schematic Reference

Radio/Navigation System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Navigation System Description and Operation

Electrical Information Reference


Circuit Testing

Connector Repairs

Testing for Intermittent Conditions and Poor Connections

Wiring Repairs


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Testing

Note

The global positioning system requires a clear line of sight to the sky to operate properly. In most cases the GPS will not have reception near tall buildings or inside structures.



1. Ignition OFF, disconnect the global positioning system antenna coax cable from the A11 Radio.

2. Ignition ON, test for 4.5-5.5 V between the GPS coax cable connection center conductor.

3. If not within the specified range, replace the A11 Radio.

4. If all circuits test normal, replace the T4E Cellular Phone and Navigation Antenna.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for radio replacement, setup, and programming