Headlamp Control Module Programming and Setup
|
Headlamp Control Module Programming and Setup
|
The following service procedures require either a programming or a setup event performed for a complete repair.
The following criteria must be met before performing the programming or learning procedure:
•
|
The vehicle must be placed on a flat level surface.
|
•
|
There must be no occupants in the vehicle.
|
•
|
Any additional cargo weight in the rear compartment must be removed.
|
•
|
All doors must be closed.
|
Headlamp Control Module Replacement
|
If the headlamp control module needs to be replaced, the following procedures must be performed:
2.
|
Perform the SPS function Headlamp Control Module - Programming and follow the on-screen instructions.
|
3.
|
Perform the SPS function Headlamp Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both control module Configuration/Reconfiguration and the appropriate control module Setup.
|
4.
|
Clear DTCs after completing the programming procedure.
|
Headlamp Control Module Reprogramming
|
Do not reprogram the headlamp control module unless directed by a service procedure or a service bulletin.
2.
|
Perform the SPS function Headlamp Control Module - Programming and follow the on-screen instructions.
|
3.
|
Clear DTCs after completing the programming procedure.
|
Setup for Component Replacement
|
The replacement of one or more components will require a setup procedure for complete repair.
If the headlamp leveling sensor is replaced, perform the scan tool learn procedure Automatic Headlamp Leveling Sensor Learn.