Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
|
|
Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
|
The inflatable restaint sensing and diagnostic module (SDM) must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the SDM will not control all of the vehicle features properly.
Ensure that the following conditions exist in order to prepare for SDM programming:
|
1.
|
The battery is fully charged.
|
|
2.
|
The MDI data link connectors are secure.
|
|
3.
|
The scan tool is loaded with the most current software version.
|
|
4.
|
All disconnected modules and devices are reconnected securely.
|
|
5.
|
This entire procedure has been reviewed before proceeding.
|
Do not reprogram the SDM unless directed by a service procedure or a service bulletin.
|
Note
|
|
The air bag indicator light may remain ON after the body control module (BCM), or SDM is replaced, and during the programming procedure for the BCM until after the procedure is completed. When installing a new SDM, there may be several DTCs set prior to programming. Once programmed, these DTCs should be in history and can be cleared.
|
The following service procedures require either a programming or a setup event performed for a complete repair:
|
Sensing and Diagnostic Module Replacement and/or Programming
|
If the inflatable restraint sensing and diagnostic module needs to be replaced and/or reprogrammed, the following procedures must be performed:
|
2.
|
Perform the SPS function Inflatable Restraint Sensing and Diagnostic Module - Programming and follow the on-screen instructions.
|
|
3.
|
Perform the SPS function Inflatable Restraint Sensing and Diagnostic Module - Setup and follow the on-screen instructions.
|
|
4.
|
Clear DTCs after completing the programming procedure.
|
If the control module fails to program, proceed as follows:
|
1.
|
Ensure the DLC and APM connections are good.
|
|
2.
|
Inspect the Techline equipment for the latest software version.
|
|
3.
|
Attempt to program the SDM. If the SDM still cannot be programmed properly, replace the SDM.
|
|
Sensing and Diagnostic Module Setup
|
The replacement of some components will require a setup procedure for complete repair. The SDM Setup Procedure must be performed if any of the following components are replaced:
|
2.
|
Perform the SPS function Inflatable Restraint Sensing and Diagnostic Module - Setup and follow the on-screen instructions.
|
|
3.
|
Clear any DTCs after completing the Setup procedure.
|
