SAAB WIS ONLINE

Power Steering Control Module Programming and Setup

Power Steering Control Module Programming and Setup


The following service procedures require either a programming or a setup event performed for a complete repair.

Variable Effort Steering Control Module Replacement

If the variable effort steering control module needs to be replaced, the following procedures must be performed:


1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .

2. Perform the SPS function Variable Power Steering Control Module - Programming and follow the on-screen instructions.

3. Clear DTCs after completing the programming procedure.


Variable Effort Steering Control Module Reprogramming

Do not reprogram the variable effort steering control module unless directed by a service procedure or a service bulletin.


1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .

2. Perform the SPS function Variable Power Steering Control Module - Programming and follow the on-screen instructions.

3. Clear DTCs after completing the programming procedure.