SAAB WIS ONLINE

Vehicle Direction Alert Alarm Warning Module Programming and Setup

Vehicle Direction Alert Alarm Warning Module Programming and Setup


The following service procedures require either a programming or a setup event performed for a complete repair.

For more information about the calibration procedure refer to Vehicle Direction Alert Alarm Warning Module Calibration .

Vehicle Direction Camera Control Module Replacement

If the vehicle direction camera control module needs to be replaced, the following procedures must be performed:


1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .

2. Perform the SPS function Vehicle Direction Camera Control Module - Programming and follow the on-screen instructions.

3. Perform the SPS function Vehicle Direction Camera Control Module - Configuration & Setup and follow the on-screen instructions.

4. Clear DTCs after completing the programming procedure.


Vehicle Direction Camera Control Module Reprogramming

Do not reprogram the vehicle direction camera control module, unless directed by a service procedure, or a service bulletin.


1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .

2. Perform the SPS function Vehicle Direction Camera Control Module - Programming and follow the on-screen instructions.

3. Clear DTCs after completing the programming procedure.


Setup for Windshield Replacement

If the windshield is replaced, the vehicle direction camera control module needs to be calibrated, the following procedures must be performed:


1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .

2. Perform the SPS function Vehicle Direction Camera Control Module - Configuration & Setup and follow the on-screen instructions.