SAAB WIS ONLINE

DTC B1016

DTC B1016

Diagnostic Instructions


• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptor

DTC B1016 XX

Vehicle Identification Number Information Not Programmed

Circuit/System Description

The control module performs a self test and vehicle identification number (VIN) verification. This DTC indicates that a VIN is not programmed or that the control module has an internal fault. The internal fault detection is handled inside the control module, no external circuits are involved.

Conditions for Running the DTC

The only requirements are voltage and ground.

Conditions for Setting the DTC

The control module has detected that the VIN is not programmed.

Conditions for Clearing the DTC


• The condition for setting the DTC is no longer present.

• The history DTC will clear after 50 fault-free ignition cycles.

• The DTC can be cleared using a scan tool.


Circuit/System Verification

Verify DTC B1016 is not set.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for control module replacement, setup, and programming