SAAB WIS ONLINE

DTC C078A

DTC C078A

Diagnostic Instructions


• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptors

DTC C078A 39

Tire Pressure Indicator Module Internal Malfunction

Circuit/System Description

The internal fault detection is handled inside the tire pressure sensor locator module. No external circuit diagnosis is involved.

Conditions for Running the DTC

The module runs the program to detect an internal fault when power up is commanded. The only requirements are voltage and ground. This program runs even if the voltage is out of the valid operating range.

Conditions for Setting the DTC

The module has detected an internal malfunction.

Action Taken When the DTC Sets

The module refuses all additional inputs.

Conditions for Clearing the DTC


• A current DTC clears when the malfunction is no longer present.

• A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.


Diagnostic Aids


• This DTC may be stored as a history DTC without affecting the operation of the module.

• If stored only as a history DTC and not retrieved as a current DTC, do not replace the module.

• If this DTC is retrieved as both a current and history DTC, replace the tire pressure sensor locator module.


Circuit/System Verification

Verify that DTC C078A is not set.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair.

Control Module References for module replacement, setup, and programming