DTC B2615
DTC B2615 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
has overviews of all diagnostic categories.
|
DTC Descriptor |
DTC B2615 02
Passenger Compartment Dimming 2 Circuit Short to Ground
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Courtesy Lamps Control
|
B2615 02
|
2
|
1
|
-
|
1. Courtesy Lamps Always Illuminated
2. Courtesy Lamps do Not Illuminate |
Circuit/System Description |
Battery voltage for the courtesy lamps is supplied at all times to the body control module (BCM). When the BCM receives a signal to command the courtesy lamps ON, it then applies voltage through the courtesy lamps control circuits to the courtesy lamps listed below.
• |
Dome/reading lamps
|
• |
Dome/Reading lamps row
|
• |
Accent lamp left lower Instrument Panel
|
• |
Accent lamp right lower Instrument Panel
|
• |
Accent lamp driver seat
|
• |
Accent lamp passenger seat
|
• |
Accent lamp driver door handle
|
• |
Accent lamp passenger door handle
|
Conditions for Running the DTC |
The BCM attempts to illuminate the courtesy lamps.
Conditions for Setting the DTC |
The BCM detects a short to ground on the courtesy lamp control circuit.
Action Taken When the DTC Sets |
The BCM will not attempt to activate courtesy lamps.
Conditions for Clearing the DTC |
• |
The condition responsible for setting the DTC no longer exists.
|
• |
A history DTC will clear once 100 consecutive malfunction ignition cycles have occurred.
|
Reference Information |
Schematic Reference
Interior Lights Dimming Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Interior Lighting Systems Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for information on diagnostic tools
Circuit/System Verification |
Command the Courtesy Lamps test ON and OFF with a scan tool. The courtesy lamps should turn ON and OFF when changing between commanded states.
Circuit/System Testing |
1. |
Ignition OFF, disconnect the harness connectors at the appropriate inoperative backlighting component.
|
2. |
Test for less than 5 Ω between the black wire of the component and ground.
|
3. |
If greater than the specified range, test the ground circuit for an open/high resistance.
|
4. |
Connect a test lamp between the control circuit of the component grey wire and ground.
|
5. |
Command the Courtesy Lamps Dimming ON and OFF with a scan tool.
|
6. |
If the test lamp is always OFF, test the control circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.
|
7. |
If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 Body Control Module.
|
8. |
If all circuit test normal, test or replace the appropriate inoperative component.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• |
Reading Lamp Replacement
|
• |
Front Floor Flood Lamp Replacement
|
• |
Front Side Door Sill Courtesy Lamp Replacement
|
• |
Rear Compartment Courtesy Lamp Replacement
|
• |
Control Module References
for BCM or instrument cluster replacement, setup, and programming
|