Windshield Wiper Arm Replacement
|
Windshield Wiper Arm Replacement
|
Callout
|
Component Name
|
Preliminary Procedure
Remove the plenum water deflector. Refer to
Plenum Water Deflector Replacement
.
|
1
|
Windshield Wiper Arm Finish Cap
Note
|
Use a small flat-bladed tool to remove finish cap.
|
|
2
|
Windshield Wiper Arm Fastener
Refer to
Fastener Caution
.
Procedure
1.
|
Position the windshield wiper arm so that the middle of the wiper blade is 10 mm below the blackout area of the lower part of the windshield.
|
2.
|
Lift the arm blade portion while pushing down the arm onto the pivot shaft.
|
3.
|
Install the windshield wiper arm fastener.
|
4.
|
Hold the windshield wiper arm stationary in position as previously stated.
|
5.
|
Torque the windshield wiper arm fastener.
|
6.
|
Release the windshield wiper arm.
|
7.
|
Repeat the same procedure for the other windshield wiper arm.
|
Tighten
35 Nm (26 lb ft)
|
3
|
Windshield Wiper Arm
|