DTC B3873
DTC B3873 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
has overviews of all diagnostic categories.
|
DTC Descriptor |
DTC B3873 02
Front Washer Relay Circuit Short to Ground
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Windshield Washer Switch Signal
|
2
|
1
|
1
|
-
|
Windshield Washer Fluid Pump Control
|
1
|
1
|
2
|
-
|
Windshield Washer Relay Control
|
B3873 02
|
1
|
2
|
-
|
Windshield Washer Fluid Pump Ground
|
-
|
1
|
1
|
-
|
1. Front Washer Inoperative
2. Front Washer Always ON |
Circuit/System Description |
The body control module (BCM) controls the windshield washer fluid pump based on an input from the window wiper/washer switch. The BCM monitors the washer switch through the windshield washer switch signal circuit. When the WASH switch is closed, ground is supplied to the front washer switch signal circuit. If this is the case, the BCM will activate the windshield washer's fluid pump and the low speed wipers on.
Conditions for Running the DTC |
• |
Ignition ON.
|
• |
The system voltage is between 9-16 V.
|
Conditions for Setting the DTC |
A short to ground is detected in the windshield washer relay control circuit.
Action Taken When the DTC Sets |
Washer operation is suspended.
Conditions for Clearing the DTC |
A current DTC clears when the diagnostic runs and passes.
Reference Information |
Schematic Reference
Wiper/Washer Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Wiper/Washer System Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for information on diagnostic tools
Circuit/System Testing |
1. |
Ignition OFF, disconnect the X2 harness connector at the X50A underhood fuse block.
|
2. |
Disconnect the X4 harness connector at the K9 BCM.
|
3. |
Ignition OFF, test for less than 5 Ω between the signal circuit terminal 60 at the X50A underhood fuse block and the signal circuit terminal 14 at the K9 BCM.
|
4. |
If the value is greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the K9 BCM.
|
5. |
If all circuits test normal, test or replace the X50A underhood fuse block.
|
Component Testing |
Output Control Tests
Ignition ON, command the Windshield Washer Relay Command ON and OFF with a scan tool. Observe that the KR11 windshield washer pump relay clicks and the G24 windshield washer pump runs.Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• |
Control Module References
for information on BCM replacement, setup, and programming
|
• |
Windshield Washer Pump Replacement (Sedan)
|