Bosch Connectors (BSK)
| Bosch Connectors (BSK) |
Special Tools
| • |
EL-38125-580
Terminal Release Tool Kit
|
|
| • |
J-38125-561
Terminal Release Tool
|
|
For equivalent regional tools, refer to Special Tools .
| Terminal Removal Procedure |
| 1. |
Disconnect the connector from the component.
|
|
| 2. |
Remove the wire dress cover, if necessary.
|
|
| 3. |
Push the wire side of the terminal that is being removed toward the connector and hold it in position.
|
|
| 4. |
Insert the J-38125-561 tool into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage the terminal retainers.
|
|
| 5. |
Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.
|
|
| 6. |
Repair the terminal by following the
Repairing Connector Terminals
procedure.
|
|
| 7. |
Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
