Delphi Connectors (Pull To Seat)
|
Delphi Connectors (Pull To Seat)
|
Special Tools
EL-38125-580
Terminal Release Tool Kit
For equivalent regional tools, refer to
Special Tools
.
Terminal Removal Procedure
|
If the terminal is visibly damaged or is suspected of having a faulty connection, the terminal should be replaced.
Follow the steps below in order to repair pull-to-seat connectors:
1.
|
Remove the connector position assurance (CPA) device and/or the secondary lock.
|
2.
|
Disconnect the connector from the component or separate the connectors for in-line connectors.
|
3.
|
Remove the terminal position assurance (TPA) device.
|
4.
|
Review the connector end view to determine the proper test probe and release tool.
|
5.
|
Insert the release tool into the front of the connector body.
|
6.
|
Grasp the wire at the back of the connector body and gently push the terminal out the front of the connector body.
|
8.
|
Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
|
Terminal Insertion Procedure
|
1.
|
Align the terminal and pull the wire from the back of the connector in order to seat the terminal.
|
2.
|
If the connector is outside of the passenger compartment, apply dielectric grease to the connector.
|
3.
|
Install the TPA, CPA, and/or the secondary locks.
|