SAAB WIS ONLINE

Measuring Voltage

Measuring Voltage


Special Tools

EL 39200 Digital Multimeter (DMM)

For equivalent regional tools, refer to Special Tools .

Refer to Test Probe Caution

The following procedure measures the voltage at a selected point in a circuit.


1. Disconnect the electrical harness connector for the circuit being tested, if necessary.

2. Enable the circuit and/or system being tested. Use the following methods:

• Turn ON the ignition, with the engine OFF.

• Start the engine.

• Turn ON the circuit and/or system with a scan tool in Output Controls.

• Turn ON the switch for the circuit and/or system being tested.

3. Select the V (AC) or V (DC) position on the Digital Multimeter (DMM).

4. Connect the positive lead of the DMM to the point of the circuit to be tested.

5. Connect the negative lead of the DMM to a good ground.

6. The DMM displays the voltage measured at that point.