Tyco/AMP Connectors (CM 42-Way)
|
|
Tyco/AMP Connectors (CM 42-Way)
|
Special Tools
|
•
|
EL-38125-580
Terminal Release Tool Kit
|
|
•
|
J-38125-12A
Terminal Release Tool
|
For equivalent regional tools, refer to
Special Tools
.
|
Terminal Removal Procedure
|
|
1.
|
Locate the connector position assurance (CPA) on the connector body and pull the CPA out. The CPA is on the wire harness side of connector.
|
|
2.
|
Disconnect the connector from the component.
|
|
3.
|
Use a small flat-bladed tool to gently pry off the dress cover by inserting the tool under the cover opposite the harness side and prying up.
|
|
5.
|
Using a small flat-bladed tool, push on the side of the nose piece retainer while pushing the nose piece forward with your thumb. This will release the terminal position assurance (TPA).
|
|
6.
|
Insert the J-38125-12A into the corresponding terminal release cavity. The release cavities are the 2 center rows of cavities on one half of the connector.
|
|
7.
|
Pressing the J-38125-12A tool in the release cavity of the terminal you are removing, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
|
|
9.
|
Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
|
