Selector Lever Cable Replacement
Selector Lever Cable Replacement |
Special Tools
DT-527-A AdjusterFor equivalent regional tools, refer to Special Tools .
Removal Procedure |
1. |
Remove the manual transmission control lever knob. Refer to
Transmission Control Lever Knob Replacement
.
|
2. |
Remove the front floor console. Refer to
Front Floor Console Replacement
.
|
3. |
Open hood.
|
4. |
Position the transmission into NEUTRAL and fix it with the
DT-527-A
pin (1).
|
5. |
Turn the gearshift guide (2) at 180 degrees and get the pins into the holes.
|
6. |
Into the vehicle pull behind the retainer for the gearshift cable to open it.
|
Installation Procedure |
1. |
Pull again the retainer (1) from the gearshift cable to fixate it. |
2. |
Turn the gearshift guide at 180 degrees and get out the pins from the holes.
|
3. |
Remove the
DT-527-A
pin from the shift control housing.
|
4. |
Install the front floor console. Refer to
Front Floor Console Replacement
.
|
5. |
Remove the manual transmission control lever knob. Refer to
Transmission Control Lever Knob Replacement
.
|