Manual Transmission Shift Lever Cable Adjustment
Manual Transmission Shift Lever Cable Adjustment |
Special Tools
DT-527-A AdjusterFor equivalent regional tools, refer to Special Tools .
Removal Procedure |
1. |
Shift transmission into NEUTRAL.
|
2. |
Remove the front floor console cover. Refer to
Front Floor Console Cover Replacement
.
|
3. |
Unlock shift lever and selector lever cable adjust locks (1), by pushing back the spring force loaded black sliding ring until self-locking.
|
4. |
Unlock the left cable trough the opening at the housing (arrow) using a suitable tool.
|
5. |
Slide transmission control lever boot upwards.
|
6. |
Press 2 latches (arrows).
|
7. |
Slide blue transmission control lever retainer ring (1) upwards.
|
8. |
Pull trigger (2) upwards.
|
9. |
Remove the lever knob.
|
10. |
Turn transmission control lever knob (1) 180° and install to transmission control lever.
|
11. |
Push the 2 pins (2) into the 2 holes (3).
|
12. |
Remove engine control module from battery tray and lay aside.
|
13. |
Block transmission control housing (2) using
adjuster
DT-527-A (1).
|
Installation Procedure |
1. |
Lock shift lever and selector lever cable adjust locks. |
2. |
Lock shift lever and selector lever cable adjust locks (1), by pushing down the two blue locking pieces WITHOUT touching/preloading the fixed shift lever.
|
3. |
Install transmission control lever knob.
Turn the transmission control lever knob back 180°. |
4. |
Press the transmission control lever knob during installation completely down. Push trigger (2) upwards.
|
5. |
Slide blue transmission control lever retainer ring (1) downwards.
|
6. |
Remove
DT-527-A
adjuster from transmission control housing.
|
7. |
Check correct shifting function.
|
8. |
If necessary repeat adjusting procedure.
|
9. |
Install the front floor console cover. Refer to
Front Floor Console Cover Replacement
.
|