| Step | Action | Yes | No | 
      
       | DEFINITION: Vehicle exhibits abnormal noise when braking; vehicle may exhibit abnormal noise during motion just after brake pedal release. 
 
 | 
      
       | 1 
 
 | Were you sent here from the Hydraulic Brake Symptom table? 
 
 | Go to 
 
 | Go to
         
          Symptoms - Hydraulic Brakes 
 
 | 
      
       | 2 
 
 | 
 
          
           
            | 1. | Inspect the disc brake system for the following conditions. 
 
 |  
          
           
            |  | • | Lining wear indicator contact with rotor 
 
 |  
          
           
            |  | • | Debris trapped between rotor and splash shield or backing plate; and/or debris trapped between rotor and linings 
 
 |  
          
           
            |  | • | Distorted, cracked or damaged linings 
 
 |  
          
           
            |  | • | Excessively worn linings 
 
 |  
          
           
            |  | • | Damaged or excessively worn caliper hardware and/or lining hardware 
 
 |  
          
           
            |  | • | Incorrectly installed, loose or missing caliper hardware and/or lining hardware 
 
 |  
          
           
            |  | • | Lack of lubrication or excessive corrosion on metal to metal contact surfaces 
 
 |  
          
           
            |  | • | Bent or damaged splash shield or backing plate 
 
 |  
          
           
            |  | • | Hard spots, heat checks, blueing discoloration of rotor friction surfaces 
 
 |  
          
           
            |  | • | Glazed rotor friction surfaces 
 
 |  
          
           
            |  | • | Bent or damaged caliper or mounting component 
 
 |  Did you find and correct a condition?
 
 
 | Go to 
 
 | Go to 
 
 | 
      
       | 3 
 
 | 
 
          
           
            | 1. | Inspect the brake assist system for the following conditions. 
 
 |  
          
           
            |  | • | Lack of lubrication or excessively worn pushrod or pedal pivots or pivot bushings 
 
 |  
          
           
            |  | • | Bent or damaged pedal pushrod, pedal, or pedal bracket 
 
 |  
          
           
            |  | • | Damaged or improperly operating vacuum booster and/or check valve, if equipped 
 
 |  
          
           
            | 2. | Adjust, repair or replace components as necessary. 
 
 |  Did you find and correct a condition?
 
 
 | Go to 
 
 | Go to 
 
 | 
      
       | 4 
 
 | 
 
          
           
            | 1. | Inspect the hydraulic brake system for the following conditions. 
 
 |  
          
           
            |  | • | Improper operation of caliper pistons 
 
 |  
          
           
            |  | • | Contaminated brake fluid 
 
 |  Did you find and correct a condition?
 
 
 | Go to 
 
 | Go to 
 
 | 
      
       | 5 
 
 | Inspect the park brake system for proper operation. Refer to
         
          Park Brake System Diagnosis
         
         . 
 Did you find and correct a condition?
 
 
 | Go to 
 
 | Go to
         
          Symptoms - Hydraulic Brakes 
 
 | 
      
       | 6 
 
 | 
 
          
           
            | 1. | Install or connect any components that were removed or disconnected during diagnosis. 
 
 |  Is the condition still present?
 
 
 | Go to 
 
 | System OK 
 
 |