SAAB WIS ONLINE

Electronic Parking Brake Control Module Replacement

Electronic Parking Brake Control Module Replacement



Callout Component Name

Preliminary Procedure

1. Release the electric parking brake using electrical release:

1.1. Set ignition in Run mode and put your foot on top of the service brake.

1.2. Press the parking brake switch down and hold for 5 seconds, then a solid yellow telltale is shown on instrument panel.

1.3. Press the parking brake switch again within 5 seconds, then a flashing yellow telltale is shown on instrument panel.

2. Release the electric parking brake using manual release:

2.1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

2.2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation

2.3. Remove the rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .

2.4. Remove the rubber plug. (Arrow)

2.5. Using a square tool with measure 3,2 mm (1/8") release the tension of the cable.


1

Electronic Parking Brake Control Module Cable

2

Electronic Parking Brake Control Module Clip (Qty: 2)

3

Electronic Parking Brake Control Module Nut (Qty: 3)

Refer to Fastener Caution .

Tighten

9.5 Nm (84 lb in)

4

Electronic Parking Brake Control Module

Procedure

Program the electronic parking brake control module. Refer to Electronic Parking Brake Control Module Programming and Setup .