DTC C028D
DTC C028D |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptors |
DTC C028D 00
Replace Park Brake Pad Malfunction
Circuit/System Description |
The parking brake control module has an internal motor, apply actuator, release actuator, and temperature sensor. The parking brake control module also contains the logic for applying and releasing the park brake when commanded by the park brake control switch. When the parking brake control module receives a signal from the switch, the internal circuit board temperature is checked to verify it is within operating range before the control module performs the requested operation.
Conditions for Running the DTC |
Ignition OFF, ACCESSORY, or RUN mode.
Conditions for Setting the DTC |
The parking brake control module has an internal counter which keeps track of dynamic applies. When the counter reaches the threshold value this DTC will set.
Action Taken When the DTC Sets |
A message and/or a warning indicator may be displayed.
Conditions for Clearing the DTC |
• |
The parking brake control module clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
|
• |
Adjust or replace the park brake pads.
|
Reference Information |
Schematic Reference
Park Brake System Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Electronic Parking Brake Control Module Description
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification |
Verify DTC C028D is not set.
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for parking brake control module replacement, setup, and programming.