Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement
|
Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement
|
Callout
|
Component Name
|
Refer to
Brake Fluid Irritant Warning
.
Refer to
Brake Fluid Effects on Paint and Electrical Components Caution
.
Preliminary Procedure
1.
|
With the engine OFF, apply the brake pedal several times until the brake pedal becomes firm to deplete the vacuum brake booster vacuum reserve.
|
2.
|
Remove the brake fluid from the master cylinder reservoir, using a suitable suction device.
|
4.
|
Disconnect the brake fluid level sensor electrical connector.
|
5.
|
Loosen the coolant reservoir from the bracket and move aside to make space.
|
|
1
|
Brake Pipe Fitting (Qty: 6)
Refer to
Fastener Caution
.
Procedure
Remove the brake pipe fittings and cap the linings to prevent brake fluid loss and contamination.
Tighten
18 Nm (13 lb ft)
|
2
|
Electronic Brake Control Module Bracket Fastener (Qty: 3)
Tighten
20 Nm (15 lb ft)
|
3
|
Electronic Brake Control Module Electrical Connector
Procedure
1.
|
Disconnect the EBCM electrical connector and carefully remove the antilock brake control assembly.
|
2.
|
Apply grease on the connector pins when installing a new electronic brake control module.
|
|
4
|
Brake Pressure Modulator Valve Bolt (Qty: 3)
Tighten
10 Nm (88 lb in)
|
5
|
Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve
Procedure
1.
|
Fill the master cylinder reservoir.
|
|