Vehicle Yaw Sensor Learn
Vehicle Yaw Sensor Learn |
The yaw sensor does not require calibration often. Calibration of the yaw rate sensor might be required after certain service procedures are performed. Some of these procedures are as follows:
• |
Electronic brake control module (EBCM) replacement
|
• |
Yaw rate sensor replacement
|
The Yaw Rate Sensor Learn procedure can be completed with a scan tool using the following steps:
1. |
Place vehicle on a level surface
|
2. |
Apply the parking brake, or set the transmission in the P position.
|
3. |
Connect the scan tool to the data link connector.
|
4. |
Ignition ON, engine OFF
|
5. |
Select Yaw Rate Sensor Reset in the Multi-axis Acceleration Sensor Module Configuration/Reset Functions list.
|
6. |
Follow the scan tool directions to complete the calibration procedure.
|
7. |
Select Yaw Rate Sensor Learn in the Multi-axis Acceleration Sensor Module Configuration/Reset Functions list.
|
8. |
Follow the scan tool directions to complete the calibration procedure.
|
9. |
Select Yaw Rate Sensor Learn in the EBCM Configuration/Reset Functions list.
|
10. |
Follow the scan tool directions to complete the calibration procedure.
|
11. |
Clear any DTCs that may be set.
|