SAAB WIS ONLINE

Steering Linkage Outer Tie Rod Replacement

Steering Linkage Outer Tie Rod Replacement



Callout Component Name

Preliminary Procedure

Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

1

Steering Linkage Outer Tie Rod Nut

Refer to Fastener Caution .

Procedure

Install NEW nut.

Tighten

35 Nm (26 lb ft) + 40 degrees

2

Steering Linkage Inner Tie Rod Nut

Tighten

60 Nm (44 lb ft)

3

Steering Linkage Outer Tie Rod


Procedure

1. Use the CH-49455 Remover to separate the steering linkage outer tie rod from the steering knuckle.

2. Inspect the steering linkage inner tie rod for bent or damaged threads.

3. Clean the tapered surface of the steering knuckle.

4. Lubricate the steering linkage inner tie rod threads with chassis lubricant. Refer to Fluid and Lubricant Recommendations .

5. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .

6. Check Toe in. Adjust if neccessary. Refer to Wheel Alignment Specifications

7. Calibrate the Steering Angle Sensor. Refer to Steering Angle Sensor Centering


Special Tools

CH-49455 Ball Joint Remover

For equivalent regional tools, refer to Special Tools .