| Step | Action | Yes | No | 
      
       | DEFINITION: A lead or pull in the direction the driver previously turned the vehicle. Additionally, after turning in the opposite direction, the vehicle will want to lead or pull in that direction. 
 
 | 
      
       | 1 
 
 | Did you review the General Description and perform the necessary inspections? 
 
 | Go to 
 
 | Go to
         
          Symptoms - Suspension General Diagnosis 
 
 | 
      
       | 2 
 
 | Verify that memory steer is present. 
 Does the system operate normally?
 
 
 | System OK 
 
 | Go to 
 
 | 
      
       | 3 
 
 | 
 
          
           
            | 2. | Lubricate the tie rod ends and the ball joints if applicable. 
 
 |  
          
           
            | 3. | Inspect the suspension system for worn or damaged components. 
 
 |  Did you find and correct the condition?
 
 
 | Go to 
 
 | Go to 
 
 | 
      
       | 4 
 
 | Inspect for binding strut bearings. 
 
 
 
          
           
            | 1. | Disconnect the strut from the steering knuckle. 
 
 |  
          
           
            | 2. | If the strut is abnormally difficult to rotate, repair or replace the upper bearing mount. 
 
 |  Did you find and complete the repair?
 
 
 | Go to 
 
 | Go to 
 
 | 
      
       | 5 
 
 | Inspect for binding in the lower ball joints. If joint is binding, replace the joint. 
 Did you find and complete the repair?
 
 
 | Go to 
 
 | Go to 
 
 | 
      
       | 6 
 
 | Inspect the wheel alignment and adjust as necessary. Refer to
         
          Wheel Alignment Measurement
         
         . 
 Did you complete the wheel alignment?
 
 
 | Go to 
 
 | - 
 
 | 
      
       | 7 
 
 | Drive the vehicle in order to verify the repair. 
 Did you correct the condition?
 
 
 | System OK 
 
 | - 
 
 |