DTC B0052
DTC B0052 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using the diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptor |
DTC B0052 00
Deployment Commanded Malfunction
DTC B0052 56
Deployment Commanded Too Many Transitions
Circuit/System Description |
The inflatable restraint sensing and diagnostic module (SDM) senses vehicle impacts and provides deployment signals to the air bags and anchor and/or retractor pretensioners when warranted. The SDM sets DTC B0052 after each command for deployment. DTC B0052 will latch and not clear until after 3 commanded deployments by the SDM. The SDM must therefore be replaced using the end of life disposal procedure.
Conditions for Running the DTC |
Ignition voltage is between 9-16 V.
Conditions for Setting the DTC |
• |
The SDM detects a frontal impact of sufficient force to warrant deployment of the frontal air bags.
|
• |
The SDM detects a side impact or rollover (if equipped) of sufficient force to warrant deployment of a seat side air bag and/or roof rail air bag.
|
Action Taken When the DTC Sets |
The SDM requests the instrument cluster to illuminate the AIR BAG indicator.
Conditions for Clearing the DTC |
• |
DTC B0052 00 is a clearable DTC and may be cleared with a scan tool without replacing the SDM.
|
• |
DTC B0052 56 is a latched DTC. This DTC cannot be erased with the scan tool. The SDM must be replaced.
|
Reference Information |
Schematic Reference
SIR Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification |
1. |
Verify that DTC B0052 00 is not set.
|
2. |
If DTC is set, clear the DTC.
|
3. |
Verify that DTC B0052 56 is not set.
|
4. |
If DTC is set, replace the K36 SDM.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for SDM replacement, setup, and programming