DTC 47 or 48
| DTC 47 or 48 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptors |
DTC 47
Parking Heater Fuel Pump Circuit Low or Circuit High
DTC 48
Parking Heater Fuel Pump Circuit Open
| Diagnostic Fault Information |
| Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|
Parking Heater Fuel Pump Supply Voltage
|
47
|
48
|
1
|
-
|
|
Parking Heater Fuel Pump Ground
|
-
|
48
|
47
|
-
|
|
1. Parking Heater Fuel Pump Malfunction
|
||||
| Circuit/System Description |
The parking coolant heater uses a fuel pump to supply fuel to the combustion chamber.
| Conditions for Running the DTC |
Ignition OFF. Battery voltage must be between 10-15 V.
| Conditions for Setting the DTC |
parking heater has recognized out of range condition for more than 2.5 s.
| Action Taken When the DTC Sets |
The parking heater will lock.
| Conditions for Clearing the DTC |
DTC must be cleared with the remote control.
| Reference Information |
Schematic Reference
HVAC Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Fuel Operated Heater Description and Operation
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
| Circuit/System Verification |
Ignition OFF, command the parking heater ON and OFF with the remote control. Verify the fuel pump turns ON and OFF with the heater.
| Circuit/System Testing |
| 1. |
Ignition OFF, parking heater OFF, disconnect the G26 Parking Heater Fuel Pump.
|
|
| 2. |
Ignition OFF, test for less than 5 Ω between the ground circuit terminal 2 and ground.
|
|
| 3. |
If greater than the specified range, replace the K87 Parking Heater Control Module.
|
|
| 4. |
Install a test lamp between the control circuit terminal 1 and ground circuit terminal 2.
|
|
| 5. |
Command the parking heater ON and OFF using the remote control. Verify the test lamp turns ON and OFF with each command.
|
|
| 6. |
If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K87 Parking Heater Control Module.
|
|
| 7. |
If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K87 Parking Heater Control Module.
|
|
| 8. |
If all circuits test normal, test or replace the G26 Parking Heater Fuel Pump.
|
|
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
