SAAB WIS ONLINE

DTC B252E

DTC B252E

Diagnostic Instructions


• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions has overviews of all diagnostic categories.


DTC Descriptor

DTC B252E 00

Child Security Lock Switch Indicator Circuit Short to Ground

Diagnostic Fault Information

Circuit Short to Ground Open/High Resistance Short to Voltage Signal Performance
Child Door Lock Indicator Control

B252E 02

1

1

-

1. Child Door Lock Indicator Inoperative



Circuit/System Description

The body control module (BCM) will provide a voltage and a ground for the child door lock indicator control circuit when the BCM receives a child door lockout command. The indicator will illuminate to indicate that the rear door latches have been disabled.

Conditions for Running the DTC

Battery voltage must be between 9-16 V.

Conditions for Setting the DTC

The DTC will set when the BCM detects a malfunction in the child security door lock switch signal circuit.

Action Taken When the DTC Sets

The indicator will be continuously illuminated.

Conditions for Clearing the DTC


• This DTC will be current for as long as the fault is present.

• When the fault is no longer present, the DTC will be a history DTC.

• A history DTC will clear after 50 ignition cycles.


Reference Information

Schematic Reference

Door Lock/Indicator Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Power Door Locks Description and Operation

Electrical Information Reference


• Circuit Testing

• Connector Repairs

• Testing for Intermittent Conditions and Poor Connections

• Wiring Repairs


Scan Tool Reference

Control Module References for information on diagnostic tools

Circuit/System Verification

Ignition ON, command the Child Security Lock Indicator ON and OFF with a scan tool. The child door lockout indicator should turn ON and OFF while changing between the commanded states.

Circuit/System Testing


1. Ignition OFF, disconnect the harness connector at the S48A Multifunction Switch - Instrument Panel.

2. Connect a test lamp between the control circuit terminal 2 and B+.

3. Ignition ON, command the Child Security Lock Indicator ON and OFF with a scan tool. The test lamp should turn ON and OFF while changing between the commanded states.

4. If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.

5. If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 Body Control Module.

6. If all circuits test normal, replace S48A Multifunction Switch - Instrument Panel.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.


• Hazard Warning Switch Replacement

• Control Module References for BCM replacement, setup and programming.