DTC B154A or B154B
DTC B154A or B154B |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
has overviews of all diagnostic categories.
|
DTC Descriptors |
DTC B154A 39
Driver Mirror Internal Malfunction
DTC B154B 39
Passenger Mirror Internal Malfunction
Circuit/System Description |
The outside mirror switch and passenger window switch are on a serial data circuit with the memory seat module as the master. The mirror select and directional control switches are inputs to the memory seat module through the serial data circuit. When the memory seat module receives switch inputs from the outside mirror switch, mirror output commands are sent to the appropriate switch through the serial data circuit. The outside mirror switch and passenger window switch control the left and right outside rear view mirrors through bi-directional motor control circuits. The motor control circuits are floating while in an inactive state and the switches will apply power and ground to the control circuits as necessary to move the mirror in the commanded direction.
Mirror position is determined by both horizontal and vertical position sensors in each of the power mirrors. The outside mirror switch and passenger window switch supply a 5 V reference, low reference, and horizontal and vertical position signal circuits to these sensors. The signal circuits are referenced from 5 V by the switches and the signal circuit voltage levels represent the mirror positions. The mirror positions are sent to the memory seat module through the serial data circuit where they are stored for memory mirror operation. When the memory seat module receives a memory recall command, the memory seat module will send the go to position commands to the outside mirror switch and passenger window switch. The switches will then drive the appropriate mirror motors to the commanded position sensor settings.
Conditions for Running the DTC |
Battery voltage must be between 9-16 V.
Conditions for Setting the DTC |
B154A 39
The outside mirror switch has determined that a hardware or software error has occurred.B154B 39
The passenger window switch has determined that a hardware or software error has occurred.Action Taken When the DTC Sets |
Power mirror functions are suspended as long as the fault is present.
Conditions for Clearing the DTC |
• |
A current DTC will clear when the fault is no longer present.
|
• |
A history DTC will clear after 40 fault free ignition cycles.
|
Reference Information |
Schematic Reference
Outside Rearview Mirror Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Outside Mirror Description and Operation (with A45) Outside Mirror Description and Operation (w/o A45)
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for information on diagnostic tools
Circuit/System Verification |
If the DTC is set, replace the appropriate outside rearview mirror switch or the passenger window switch.
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for outside rearview mirror switch or passenger window switch replacement, setup, and programming