SAAB WIS ONLINE

Sunroof Window Replacement - Front

Sunroof Window Replacement - Front

Removal Procedure


1. Open the sunshade.

2. Open the sunroof to the vent position.


3.
Note

Ensure the position disk does not drop off.


Remove the sunroof window rear bolts, two on each side.

Remove the 4 bolts.

4. Open the sunroof to the half open position.

5.
Note

Ensure the position disk does not drop off.


Remove the front window bolts, one on each side.

Remove the 2 bolts.

6. Remove the window.


Installation Procedure


1. Insert the window.

Align and insert the window on one side.


2.
Note

Position disk may not rotate, since it can cause scratches in the rear glass cover.


Install the front window.


2.1. Insert the 2 long position window panes (1) if equipped.

2.2. Install the 2 screws (3) with washers (2).

3. Close the sunroof until the rear part is in the vent position.

4.
Note

Position disk may not rotate, since it can cause scratches in the rear window.


Install the sunroof window rear bolts.

4.1. Insert the 4 long position window panes.

4.2. Install the 4 screws with washers.

5. Close the sunroof.

Inspect the gap 11.0 + or -0.3 mm (0.43in).


6. Refer to Fastener Caution

Tighten the sunroof, rear.

Press the seal lightly down (arrow).

Tighten

Tighten the 4 bolts to 4 Nm (35 lb in).


7. Open the sunroof to the half open position.

8. Tighten the sunroof window front bolts.

Tighten

Tighten the 2 bolts to 4 Nm (35 lb in).

9. Install the front air deflector covers.

Insert and clip in covers.

10. When replacing the motor. Refer to Sunroof Motor/Actuator Initialization/Teach Process.

11. Verify the operation of the sunroof.

12. Close the sunroof.